Results 1 to 3 of 3

Thread: Very new to electrics and need help

  1. #1
    Newbie Member
    Join Date
    Dec 2012
    Posts
    1

    Very new to electrics and need help

    i recently purchased the techone pulama and i need a motor, c20 6g servos and a 18 amp esc,
    im not concerned about the esc but where its 3d and big throws i was wondering if 5.5g turnigy servos would be ok to start and i have the c20 brushless outrunner 2050kv aswell thanks in advance fer ya help is this setup ok to learn
    Last edited by rcflyer327; 12-23-2012 at 06:42 PM.

  2. #2
    Newbie Member
    Join Date
    Dec 2012
    Location
    lakeland
    Posts
    3
    Is this your first 3d plane sir?

  3. #3
    Newbie Member
    Join Date
    Dec 2012
    Location
    lakeland
    Posts
    3
    Well its better to hv the exact correct servos for the plane nd u dont want anything less than wat is recommended is it epp ep or depron foam? I have a crack yak 55 from twisted hobbies nd they saod I needed 2 5 gram servos for rudder and elevator and one 9 gram servo for the aileron and I did jus tht nd it works great!! And 5.5g servos shouldbe ok but it

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •