Walkera Devo 7 and DEVO RX701 Binding
A buddy of mine has a new DEVO 7 Radio and a DEVO RX701 Reciever.
He has them installed in a BlitzRCWorks Giant MX2 Pro.
We cannot seem to get the Radio to bind with the receiver.
Neither of us are familar with Walkera's Equipment.
The only info I can find in the Broken English Owners Manual has to do with Direct ID Setup.
Do I have to do Direct ID Binding?
Can someone please give step by step instructions on the binding process including the bind plug?
Thanx
~D~
Last edited by Dalrock; 05-22-2012 at 10:44 PM.
10% Luck, 20% Skill,
15% Concentrated Power of Will,
5% Pleasure, 50% Pain,
And a 100% Reason to Remember The Name!
with out to much detail lets try something simple to start, , try power on tx first and the bird, that dont work try other way, that dont work go in to the tx and start a whole new model, leave all the curves and dr alone, just set the swash type, ie... normal is 1 etc,,reverse servos if needed,,, shut down tx and try power sequece above again both ways,, and see what you got,,, hope this helps,,,,
make sure the tx is set to plane not chopper,,,,
Last edited by Ghostrydyr; 05-22-2012 at 10:25 PM.
Thanks
Will give this a try in the morning
~D~
Last edited by Dalrock; 05-22-2012 at 10:37 PM.
10% Luck, 20% Skill,
15% Concentrated Power of Will,
5% Pleasure, 50% Pain,
And a 100% Reason to Remember The Name!
did it work??, which method worked for you?
Have fun while you can
Posting Permissions
Reply With Quote
Bookmarks