How Do I Bind My 2.4ghz FLYSKY Radio System?
Put batteries into the transmitter
Place bind plug into the BATT slot on the receiver
Connect a receiver battery (6.0v) to any channel on the receiver OR place an esc with battery into channel 3 on receiver
Press and HOLD bind button on transmitter and turn on transmitter
Continue holding bind button without releasing and observe the RECEIVER light. The receiver light should go out indicating binding successful. May take up to 10+ seconds
Remove Bind Plug and place battery into BATT slot OR ESC into channel 3 with battery
Install servos and test
If fail. Repeat from step one
Re: How Do I Bind My 2.4ghz FLYSKY Radio System?
This is good info as my Flysky came with two different binding instructions and both were weird = Dana!
I FLY LOW,
Thanks for this old 2010 post--I was going crazy figuring out the bind instructions by experiment.
Please check this video. It might be helpful