need some help

[helikido]

hey i crashed again since i did not straighten it right. repair cost 22.26 bucks. striped a gear boom was bent fly bar bent and theres no feathering shaft STILL. i just can't get enough. just sit there and laugh at a newbei that crashes two times a week. lol,lol,lol,lol,lol,lol,lol,lol,lol,ooooooo,ll,oo,ll,lolollololololololololololololololololololololololololololololololololololololololololoolololololololololololol. ahahahahahahahaha. sorry for dulling this post very sorry. i just can't stop laughing. bwaaahahahahah.

[pinoydad]

maybe get back on xbox..you are confusing a lot of people he kido

[helikido]

maybe get back on xbox..you are confusing a lot of people he kido

forget about the xbox and ps2. now it's all about basket ball. i just made it today.

[grumpy]

Falcon 400 does not have a tail drive belt...It has a gear driven tail, From my limited exp. on the falcon I have found that any contact with tail causes the carbon drive shaft to snap and loose ethier the front or rear drive gear. Had to replace mine every crash no matter how slight.

[nheli]

grummpy,  you are right, falcon400 is shaft driven like the shogun v1, I mistaken it as a shogun v2.

[Captain Crunch]

This happened to me on my HBK2 belt heli. The set screw in the tail blade holder was loose so when I tightened it it helped somewhat. The main thing I found later was the pitch on the main blades was'nt set right so the heli flew without enough head speed so the tail wasn't rotating fast enough to give it the proper push.
Maybe this helps, Lorne

[Mustang67]

Don't know about all the talk here, but my falcon 3D 400 has a gear driven tail. It is impossible for it to spin backward if it is put together properly. The possible reasons are as follows:

one way bearing in upside-down/rotor would also spin wrong way

Tail blades are improperly installed making it look like they are spinning backward

Tail grips are improperly installed - ball end of grip trailing instead of leading.

Good Luck!