Belt CP CNC upgrade

[tecnambob]

Hi

I just purchased CNC main rotor and tail upgrade kit for my belt cp as I crashed it and bent the feathering shaft and dented the tail boom. Will it fly again with just these upgrades fitted OR will I need to purchase something else for it to fly. Also bought 15pc tool kit ( http://www.xheli.com/esbecpcnccod.html)

regards

Newbie

[kloner]

Are you saying you did not get the tail boom? What did your blades look like after the crash? Anything that looks questionable usually last very short so you might set yourself up for failure sooner than later if you didn't change it all out.

[tecnambob]

Are you saying you did not get the tail boom? What did your blades look like after the crash? Anything that looks questionable usually last very short so you might set yourself up for failure sooner than later if you didn't change it all out.

Yep I bought two new sets of blades as well they were trashed? So will I need to make extra purchases apart from those I already made?

[kloner]

if your tail is bent at all, your gonna want to change it out. without seeing it, it is hard to say if you got everything. I've had crashes where you fix the obvious, turn it on and find out you smoked the receiver.  One thing that goes out everytime i crash is the gear set, your new head doesn't have that either. replacing the head eliminates lots of little parts you won't need.