Throttle up, swashplate down, need help.

[vharbor]

Hi all,
I am new to heli and just bought a ESKY 6 CH Radio 0406A from XHELI. For my new EXI 450 copter, I installed:
- CH1: Aileron
- CH2: Elevator
- CH3: Throttle
- CH4: Rudder
- CH6: Pitch.
I use ESKY Receiver 0420, every control is correct (from aileron to rudder) except throttle, when I move it up, the swashplate moves down. If I reverse Ch3, I can not start the throttle from lowest position (Throttle stick is on left side).
Do I make mistakes? I really appreciate any support from this Forum to help me out.
Thanks a lot.
Vharbor.

[Paladin]

Just unplug your servos and plug a spare servo into each channel and see which stick is actually controlling it.
same for the rest of the channels.
write down which stick/switch controls each so you know next time

[dditch66]

Esky radio has servo reverse but not swash reversing, either it will work or your sOL.
you can try changing CH1 and Ch6 but if it does not work, then your SOL.

Computer radios allow you to change servo reversing to get the swash moving up and down, then swash mixing to handle aileron/elevator lean for the swash

[15Crewdawg]

vharbor
I had the same issue with my Belt CP V2 after changing my cyclic servos. If your cyclic servos respond correctly to stick input but the throttle is reversed, your SOL as Dditch said. You need a computer TX.